When the bottle embryo enters the oven, the embryo base also rotates, which can ensure that the bottle embryo fixed on the embryo base is heated evenly.Temperature affects bottle blowing effect .During testing, find the optimum temperature range for the bottle to be made.
1) Before each shift starts, lubricating oil must be added to the moving parts once (manipulator, manipulator rail, opening and closing mold rail, etc.).
2) Swing arm can be added once a week, and large chain and small chain of heating machine can be added once a month. Check regularly whether the reducer of the host machine and the reducer of the heating machine are short of oil. The bearing of the host machine can be added once every three months.
3) Before production, check whether the moving parts are firm, whether the screws are loose and fall off, especially where the impact force is strong and whether the transmission part is abnormal.
4) Check whether high pressure air source, low pressure air source, power supply and water source are normal.
5) check the emergency stop switch, safety door switch, protection device to detect whether the switch is normal.
6) Check whether the heating head, upper embryo and embryo dropping part work normally.
7) check whether the lamp is damaged, broken, if there is abnormal need to be replaced in time.
8) Check whether the pneumatic components leak and whether the action is sensitive.
9) When the magnetic valve of the automatic bottle blowing machine is abnormal, it should be cleaned in time (3.5 million yuan for each bottle blowing).
Half-finished products and spare parts are well prepared
Mass production of semi-finished products and parts can ensure that the equipment required by most customers can be completed within one month！
The whole production will be connected and test running in factory
Before leaving the factory, each device will be tested many times to ensure that there is no problem with each device that customers get！